Set of K03 wholemilled fillet clamps (2pcs)

TSPROF Whole-milled fillet clamps are designed for clamping knives with a spine thickness of up to 3.5 mm and are suitable for TSPROF K03, Kadet and Pioneer sharpeners.

The shape of the outer surface is radially convex, which allows you to set minimum sharpening angles. The minimum sharpening angle is 7.2 degrees. The clamps are made of a single piece of aluminum and allow you to adjust the clamp to any shape of the blade and ensure the symmetry of the installation.

Thanks to the two gripping points, the bending of the blade is excluded. It is possible to move the clamps independently, along the entire frame. There is no need for calibration.

Suitable for: kitchen and fillet knives with a narrow spine, small folding and pocket knives and other narrow long knives. 

Recommended blade length: 30-300 mm

Minimum width of the knife: 10 mm

The thickness of the jaws at the ends: 1 mm

Clamp width: 21 mm, 2 pcs.

The gap between the jaws in the free state: 4 mm

Maximum spine thickness: 3.5 mm

Comes with a 2.5mm hex L-key.

Designed for K03. Also works with Kadet and Pioneer sharpeners. *

*Please bear in mind that K03 clamps are longer than Kadet and Pioneer clamps and using these clamps with Kadet or Pioneer will affect the range of angles.